***
My store is not taking any orders today due to health reasons which limit to my productivity.
***
My custom harmonicas, combs and tools are made to order. If items are out of stock on my website, it's likely due to my workload is at the limit. Please see my dealers for all items I offer.
Maximum production times may be up to 16 business days for combs and tools. Current production time for custom harmonicas are shown on the top of the custom page.
Thanks for your support.
Andrew
This is part of a series of checklists I am making available to you.
Click the "Printer-friendly version" link at the bottom of the page and feel free to print out as many copies as you like!
----------
Reed replacement checklist
version 2016/07/24
Items needed
___ Hammer
___ Reed removal pin
___ Reed removal spine
___ Brick or anvil
___ M1.4 tap
___ M1.4 screws
___ Reed wrench
___ Flush cut pliers
___ Drill press or Rotary tool with reamer bit
Remove bad reed
___ Identify bad reed
___ Place correct rivet head into reed removal spine hole (reed tip points away from spine)
___ Punch out rivet
___ Flip reed plate around and place on flat part of reed removal spine
___ Flatten hole using flattening pin
___ Tap hole using M1.4 tap. De-burr as needed
Prepare new reed
___ Obtain new reed
___ Enlarge rivet hole using drill press (1/16th inch bit) or rotary tool with reamer
___ De-burr as needed
___ Flatten rivet pad using flattening tool and flat part of reed removal spine
Install new reed
___ Position new reed into slot standing up and pinch it with your fingers
___ Insert M1.4 screw and tighten all the way
___ Loosen the screw very slightly
___ Look at a light source through the slot and align the reed
___ If the reed doesn't align, remove the screw, enlarge the hole in the rivet pad and repeat all the steps to prepare the reed
___ Pinch the base of the reed very tightly to hold the reed in place and tighten the screw
___ Re-confirm reed position and alignment
___ Snip off back of screw
___ Re-confirm tightening of screw
___ Re-align reed
___ Flat sand draw reed plate or sand down tip of screw in blow plate
Fix reed shape and tuning
___ Correct reed curve using pressure and counterpressure
___ Tune reed