*** My store is not taking any orders today due to health reasons which limit to my productivity.
***
My custom harmonicas, combs and tools are made to order. If items are out of stock on my website, it's likely due to my workload is at the limit. Please see my dealers for all items I offer.
Maximum production times may be up to 16 business days for combs and tools. Current production time for custom harmonicas are shown on the top of the custom page.
Thanks for your support.
Andrew
Reed Replacement Kit (Freehand)
Submitted by Andrew on Sun, 09/20/2015 - 08:47
CAD$70.00
"You don't need to throw away a harmonica because of a blown reed."
Includes:
- Stainless steel reed replacement screws (75 pieces screws and washers)
- M1.4 tap and pin vise
- 3/64" drill bit
- Reed removal spine and Rivet Bar
- Hardened and tempered O1 steel reed removal pin
- Flattening pin
Two types of screws are provided. 5mm Phillips head screws are easy to handle but require trimming once in place. The shorter flat head screws are harder to pick up with your fingers but don't need to be cut. (Dip your screwdriver in Vaseline to make the tiny screw stick to the tip!) Washers are a big help to keep the reed in place as you tighten the screw. With a little practice, you won't even need to use a washer.
__________________________________
You will need some extra items. These items are so common that I chose not to include them in the kit to keep the cost down. They are easily found at a hardware store for less than a total of $10.
Items you will need (not included):
- Small Phillips head screwdriver
- flush cutting pliers
- A brick or a small anvil; or something else that's flat and heavy. At a minimum, you need two pounds of weight. The more mass you have under your reed plate, the easier it will be to do the job.
- Flat sanding surface (a flat board and a sheet of 220 grit sandpaper - the same thing as in preparing a reed plate for a flat comb) and a little extra sandpaper.
- 1/16", 5/64" and 3/32" drill bit
- small hammer
- A reed wrench (you won't find this in a hardware store... Click below to add one to the kit.)
- New reeds. You can scavenge a new reed from another reed plate or contact Hohner or Seydel and buy individual reeds from them.
You can scavenge a reed from one harmonica and put it into another just as long as they have the same slot dimensions. Players have been doing this for decades.
Hohner Marine Band reeds have two slot configurations. Here's a compatibility chart: